Auto-Sleepers Symbol Plus 2018, Manual

Page: 109 / 126

10-5
CARE OF YOUR MOTORHOME
TROUBLESHOOTING
The following are a series of fault finding charts to which you should refer in the event of
problems you may have regarding 230/12V, LPG and water. This should be used as a guide only,
and in the case of an electrical fault, where a fuse has blown or an MCB tripped out, the fault
must be located before replacing the fuse. If a fault is suspected with the LPG system, consult a
GAS SAFE registered technician.
If in doubt consult a qualified technician or your local Auto-Sleeper dealer.
12V TROUBLESHOOTING CHART
Symptom Cause Remedy
Habitation 12V does not Main 20A fuse blown Check/Replace
operate Battery Discharged Recharge
Switch on control panel in off Switch to on
position
Vehicle ignition ‘on’ Switch ‘off’ ignition
Habitation battery not Main 20A fuse blown Check/Replace
charging Relay fault Refer to dealer
Contacts dirty/loose on Clean and check for tightness
battery terminals
Poor earthing Check earthing to chassis point
Battery does not hold its Failed battery Electrically test and replace if
charge necessary
Current being drawn Check all appliances are off
when not in use
Battery discharges over a Poor battery cell condition Electrically test battery
short time with appliances Failed battery Change battery
operating Battery not fully charged Fully recharge battery
No power to one or more Circuit fuse blown Find fault and replace fuse with
12V appliances same rating
Water pump not operating Switch on panel ‘off’ Switch it ‘on’
Pressure switch on pump not Refer to dealer
operating
Fuse 4 blown Find fault and replace fuse with
same rating
No power on 12V socket Fuse 9 blown Find fault and replace fuse with
outlet same rating
12V plug incorrectly Check plug
connected/wired