Auto-Sleepers Symbol Plus 2018, Manual

Page: 90 / 126

9-26
FITTED EQUIPMENT
Before Use
Prepare the waste holding tank
•
Remove the waste holding tank through
the service door (01).
• Place the waste holding tank upright and
turn the pour out spout upwards.
• Remove the cap from the pour out spout
(02).
• Check the correct dosage of Thetford
waste holding tank additive on the
package.
• Add the stated dosage to the waste
holding tank (03)
• Add
±
3L of water to the waste holding tank
to ensure that the bottom of the waste
holding tank is covered (03).
• Screw the cap back onto the pour out
spout.
• Slide the waste holding tank back into its
original position via the service door (04).
Use of the toilet
Turning the toilet bowl:
• Close the cover and use both hands to
rotate the bowl to the desired position
(max 90
°
clockwise and 170
°
counterclockwise) (06).
Opening the blade:
• Open the blade by moving the blade
handle from left to right (07).
• Always close the blade completely after
use.
Note: The toilet can be used with the blade
open or closed.
Note: The toilet can withstand a maximum
load of 120kg. Make sure you do not overload
the toilet.
Flushing the toilet
• Make sure the blade is open.
• Press the flush button and hold it for
several seconds to flush the toilet (08).
Note: Ordinary toilet paper can cause
clogging. Use Thetford Aqua Soft toilet paper
for your toilet. This toilet paper is super-soft,
dissolves quickly, prevents clogging and
makes it easier to empty the waste holding
tank.
Emptying the waste holding tank
Your toilet has a 1-level indication for the
waste holding tank. When the slide turns from
green to red, the waste holding tank is full.
Emptying the waste:
• Remove the waste holding tank (01).
• Fold out the pull handle unit until it is fully
extended.
• Pull the tank to an authorised waste
disposal point (10).
• Place the waste holding tank upright and
turn the pour out spout upwards.
• Remove the cap from the pour out spout
(02).
• Press and hold the vent button with your
thumb while the pour out spout is pointing
downwards to empty the waste holding
tank (11).
• Add
±
5L of water to the waste holding
tank and replace the cap (12).
• Gently shake the tank to clean it (13).
Empty the waste holding tank again (11).
• Remove the float from the waste holding
tank by turning it clockwise and rinse the
float with tap water (14).
• Fold in the pull handle until it clicks into
place.
• Slide the waste holding tank into the toilet
and close the service door (04).
• If you want to continue using your toilet
after emptying the waste-holding tank,
prepare the waste-holding tank again.
See Before use.
WARNINGS: To prevent water damage to
your caravan or motorhome, do not travel
with a waste holding tank that is more
than 3/4 full. This may cause leakage
throug the venting system.
Do not leave water in the toilet bowl if the
toilet is not being used. This does not
help to reduce unpleasant smells and only
leads to flooding.