Auto-Sleepers Symbol Plus 2018, Manual

Page: 83 / 126

9-19
FITTED EQUIPMENT
Always use the gas connection or mains
voltage to start up and cool. Operating on
12V is only effective while the engine of the
vehicle is running.
If the ‘auto’ function on the refrigerator is
selected, but no source is available, a light in
the on/off switch blinks red.
The performance of the refrigerator, by
operation on 12V, is dependent on the
thickness and length of the wiring and the
overall installation of the vehicle.
When selecting gas, the flame should be
ignited within 30 seconds. If the system fails,
restart the refrigerator and select the gas
source again.
From about 1000m above sea level problems
of a physical nature can occur when lighting
the gas. This does not mean that the
refrigerator is not working properly.
Selecting cooling level
After switching on the
refrigerator, push the
cooling level button
several times (as
illustrated). Push until the
desired level is selected.
Your refrigerator meets the climate class SN
requirements according to EN ISO
15502:2005 at a temperature of 10ºC to
32ºC.
We advise to set the refrigerator on cooling
level 3, with an ambient temperature between
15ºC and 25ºC. A higher temperature needs
a higher cooling level, a lower temperature a
lower level.
To improve the cooling performance of
your refrigerator in high temperatures,
Thetford advises to install the Ventilator Kit. It
helps to detract the warm air quicker to the
vents. The ventilator kit is suitable for all
Thetford refrigerators.
Control of optional extras
Anti condensation
present on refrigerator Model B
To prevent the control panel from
condensation, the anti-condensation function
is automatically switched on (no symbol
visible). Only switch off this function when
little energy is present.
Push on the anti-
condensation button. The
symbol on the control
panel will light up.
Use of refrigerator compartment
You can organise your refrigerator as desired
by moving the storage shelves and door bins
in height.
Make sure the door can still be closed after
reorganising shelves and bins.
Moving storage shelves
Turn the plastic clamp on
the right side of the
storage shelf upwards (as
illustrated). Lift the right
side a bit, and move the
storage shelf to the
desired position.
First place the left side of
the storage shelf in the refrigerator wall, then
the right side in the corresponding groove.
Turn the plastic clamp downwards. Your
storage shelf is fixated again.
Moving door bins
Push a door bin out of
the locking with both
hands (as illustrated).
Place this door bin back
in the desired position
and push it back on the
locking. The door bin is
fixated again.
Organising food
After a minimum of 8 hours of cooling, the
food can be placed in the refrigerator. Do not
completely cover the cooling fins with food, to
preserve an optimal performance of the
refrigerator. Make sure air can still circulate
around the fins.
Lowest
cooling level Highest
cooling level