AudioCodes mediapack MP-500, User Manual

Page: 334 / 574

SIP User's Manual 334 Document #: LTRT-12801
MP-500 MSBG
Parameter Description
Out-of-Service (Busy Out) Parameters
Web/EMS: Enable Busy Out
[EnableBusyOut]
Determines whether the Busy Out feature is enabled.
ƒ
[0] Disable = 'Busy out' feature is not used (default).
ƒ
[1] Enable = 'Busy out' feature is enabled.
When Busy Out is enabled and certain scenarios exist, the
device performs the following:
A reorder tone (determined by FXSOOSBehavior) is played
when the phone is off-hooked.
These behaviors are performed upon one of the following
scenarios:
ƒ
Physically disconnected from the network (i.e., Ethernet
cable is disconnected).
ƒ
The Ethernet cable is connected, but the device can't
communicate with any host. Note that LAN Watch-Dog
must be activated (the parameter EnableLANWatchDog
set to 1).
ƒ
The device can't communicate with the proxy (according
to the Proxy Keep-Alive mechanism) and no other
alternative route exists to send the call.
ƒ
The IP Connectivity mechanism is enabled (using the
parameter AltRoutingTel2IPEnable) and there is no
connectivity to any destination IP address.
Notes:
ƒ
The FXSOOSBehavior parameter determines the
behavior of the FXS endpoints when a Busy Out or
Graceful Lock occurs.
ƒ
FXO endpoints during Busy Out and Lock are inactive.
ƒ
Refer to the LifeLineType parameter for complementary
optional behavior.
Web: Out-Of-Service Behavior
EMS: FXS OOS Behavior
[FXSOOSBehavior]
Determines the behavior of undefined FXS endpoints and all
FXS endpoints when a Busy Out condition exists.
ƒ
[0] None = Normal operation. No response is provided to
undefined endpoints. A dial tone is played to FXS
endpoints when a Busy Out condition exists.
ƒ
[1] Reorder Tone = The device plays a reorder tone to
the connected phone / PBX (default).
ƒ
[2] Polarity Reversal = The device reverses the polarity of
the endpoint, marking it unusable (relevant, for example,
for PBX DID lines). This option can't be configured on-
the-fly.
ƒ
[3] Reorder Tone + Polarity Reversal = Same as 2 and 3
combined. This option can't be configured on-the-fly.
ƒ
[4] Current Disconnect = The device disconnects the
current of the FXS endpoint. This option can't be
configured on-the-fly.
Note: This parameter is applicable only to FXS interfaces.