CM5000 User Manual
UM-CM5000-FW3.5.2.0-REV0.0
2019-07-08
www.ateme.com
Page 115
As we can see on the previous figure, the encoder must be able to reach the same destination through two network
interfaces using two different routes. This can be done by binding the routes to an interface.
Figure E.2. Route configuration sample
In the previous sample, we defined two routes to reach the 10.86.0.0 sub-network:
• One passing through the gateway 10.82.7.12 when the packets are sent on Stream 1.
• The other one passing through the gateway 10.83.7.12 when the packets are sent on Stream 2.
Finally, we have to configure the output to give the encoder the IP address and port of the destination and the interfaces
it should use.
Figure E.3. Encoder configuration sample
