CM5000 User Manual
UM-CM5000-FW3.5.2.0-REV0.0
2019-07-08
www.ateme.com
Page 10
The glossary of this document is partially extracted from the Wikipedia encyclopedia.
Trademarks
ATEME, the ATEME logo, Kyrion and the Kyrion logo are all trademarks or registered trademarks of ATEME
Corporation. The CM5000 clustering technology - as well as other technologies included in CM5000 - are protected
by patents or pending patent applications in the U.S. and other countries. All other trademarks or registered trademarks
are property of their respective owners.
1.4. Precautions
Only qualified persons are authorized to carry out maintenance on this device.
Read the Users' Manual carefully, and follow the correct procedure when setting up the device.
Do not open your CM5000 or attempt to disassemble or modify it, unless instructed by an ATEME representative. To
avoid any risk of electrical shock, fire, short-circuiting or dangerous emissions, never insert any metallic object into
the enclosure. Your CM5000 contains no user-serviceable parts. If it appears to be malfunctioning, have it inspected
by a qualified ATEME Technical Support representative.
Never expose your device to rain, use it near water, or in damp or wet conditions. Never place objects containing
liquids on the CM5000, as they may spill into its openings; doing so increases the risk of electrical shock, short-
circuiting, fire or personal injury.
Basic electrical safety precautions should be followed to protect you from harm and the system from damage:
• Be aware of where the On/Off power switch is situated on the chassis; as well as the rack's emergency power off-
switch. Check also where the disconnection switch or electrical outlet is located.
• Do not work alone when working with high voltage components.
• Power should always be disconnected from the system before opening it. When disconnecting the power, you
should first power down the system and unplug the power cords of the power supply.
• Ground pin shall be connected to earth for safe operation.
For the 220VAC version:
• Only the provided power supply cord must be use to power the CM5000. This power supply cord includes a
grounding plug and it must be plugged into a grounded electrical outlet. If you should use a different power supply
cord, make sure it is compatible with your locale electrical power supply.
• The mains plug (or the mains plugs for dual plug version) is used as the disconnect device and shall be easily
accessible.
For the 48VDC version:
• The internal fuse of the DC filter board shall be replaced by a 5x20mm medium-acting 8A 250V fuse, like LittleFuse
234 series.
• The rear connector is used as the disconnect device and shall be easily accessible.
