Astraada DRV-24 frequency inverters Function Parameters
65
Functio
n code
Name
Detailed instruction of parameters
Defaul
t value
Modify
value
output the signal of “frequency arrival”, see the
diagram below for detailed information:
The setting range:0.00Hz~P00.03(the Max.
frequency)
P08.37
Energy
Braking
enable
This parameter is used to control the internal
braking unit.
0:Disabled
1:Enabled
Note: Only applied to internal braking unit.
0
○
P08.38
Energy
braking
threshold
voltage
After setting the original bus voltage to brake
the energy, adjust the voltage appropriately to
brake the load. The factory changes with the
voltage level.
The setting range:200.0~2000.0V
In order to prevent customers set the value is
too large, it is recommended setting range:
Voltage
230V
400V
Range
375~400V
685~750V
220V
voltage:
380.0V
○
380V
voltage:
700.0V
P08.39
Cooling fan
running
mode
0:Rated running mode
1:The fan keeps on running after power on
0
○
P08.40
PWM
selection
0x000~0x0021
LED ones: PWM mode selection
0: PWM mode 1, three-phase modulation and
two-modulation
1: PWM mode 2, three-phase modulation
LED tens: low-speed carrier frequency limit
mode
0: Low-speed carrier frequency limit mode 1,
the carrier frequency will limit to 1k or 2k if it
exceeds 2k at low speed
1:Low-speed carrier frequency limit mode 2,
the carrier frequency will limit to 4k if it
exceeds 4k at low speed
2: No limit
0x01
◎
P08.41
Over
commission
selection
LED ones
0: Invalid
1: Valid
0x00
◎
Summary of Contents for AS24DRV4075
Page 1: ...Operation Manual Astraada DRV 24 Frequency inverters ...
Page 2: ......
