12
800-810-WIRE (9473) • www.sargentlock.com • A7690C
4/15/08
Copyright
©
2008 SARGENT Manufacturing. All rights reserved.
Reproduction in whole or in part without the express written permission of SARGENT Manufacturing is pr
ohibited.
Exit Device Installation (continued)
Installing 59-WD8600/12-59-WD8600 Concealed Vertical Rod Exit Devices
PREPARE DOOR AND INSTALL RODS INTO DOOR
Push rail
Chassis arm
Cover
(4) #10
Wood Screws
(1) #10-
24 3/4”
Machine
screws
Center case
chassis
Wire holder
Rail wire
connector
Lock Down Key —
7/32” hex key
To operate: Depress
pushrail, insert hex key
and turn clockwise.
(Not furnished with 12-)
CAUTION – BEFORE STARTING:
• Check hand of door (This device is handed and not reversible)
• Door should be fitted and hung
• Verify box label for size of exit device, function and hand
IMPORTANT: Surface of door where
exit device is to be applied must be
flush. Clear away any raised projections
to allow exit device to rest on flat
surface of door
ATTACH CHASSIS
1. Feed wire and connector through chassis as shown
2. Snap the ElectroLynx connectors together and gather the
excess wire in the top section of the chassis. Wire tie in place
3. Finish installation per instruction sheet A3937 and
Section 10 within this manual
Refer to Instruction sheet A3937
Mounting
bracket
Top
case
Top bolt’s flat
Top
bolt
Top
rod
Inner
chassis
(2) #10 x 1 1/4”
Wood screw
Bottom
rod
Bottom
bolt
Bottom
plate
Center
case
chassis
*(2) 6-32 x 3/8”
Long machine screw
Wire &
connector
Wire hole
WD 8600 Main Mechanism Dwg
Rail assembly
A7690C.indd 12
11/8/18 9:02 AM
