Ashley AG23, Owner’S Instruction And Operation Manual

Page: 35 / 96

© 2021 United States Stove Company
35
OPERATING INSTRUCTIONS
FIRST-TIME LIGHTING INSTRUCTIONS
WARNING:
WHAT TO DO IF YOU SMELL GAS
• DO NOT LIGHT ANY UNIT.
• DO NOT TOUCH ANY LIGHT SWITCH
• DO NOT USE ANY PHONE IN YOUR BUILDING.
• CALL YOUR GAS SUPPLIER FROM A
NEIGHBOR’S PHONE.
• FOLLOW THE PROVIDER REPRESENTATIVE’S
INSTRUCTIONS.
• IF YOU CANNOT REACH YOUR GAS
SUPPLIER, CALL THE FIRE DEPARTMENT
FOR ASSISTANCE.
WARNING:
IF YOU DO NOT FOLLOW THESE INSTRUCTIONS
EXACTLY, A FIRE OR EXPLOSION MAY RESULT
CAUSING PROPERTY DAMAGE, PERSONAL
INJURY, AND LOSS OF LIFE.
SAFETY INFORMATION
• This appliance is equipped with an ignition
device which automatically lights the pilot. Do
not attempt to light pilot by hand.
• Before operating, smell all around the area for gas.
Be sure to smell next to the floor because some
gas is heavier than air and will settle on the floor.
• Toggle master switch to on. The burners will not
ignite unless the master switch is on.
• Use only the supplied remote control to light the
pilot. This valve will not operate if the pilot is not
lit and stable.
• Do not use if any part has been underwater.
Immediately call a qualified service technician
to inspect and replace any component which
has been under water. Attempted operation may
result in fire or explosion resulting in property
damage, personal injury, and loss of life.
OPERATING INSTRUCTIONS
1. Read the above safety information carefully
before proceeding.
2. Do not attempt to light the pilot by hand; the
door must remain on this appliance during pilot
ignition, except for the first time lighting.
3. Press the On/Off button on remote control to
begin the ignition sequence.
4. There will be an audible beep and then the
igniter will begin to spark. After the pilot lights
and is established, the valve will automatically
open and the burner will light. The burner
will initially light to full flame. Adjust it to an
appealing setting with the remote (see “Remote
Operating Instructions” in this manual).
WARNING:
IF THE PILOT FAILS TO LIGHT, THE SYSTEM
WILL “LOCKOUT”. PRESS ON/OFF BUTTON ON
REMOTE CONTROL TO TURN OFF THE SYSTEM.
ALLOW FIVE MINUTES FOR ANY GAS TO
DISSIPATE BEFORE ATTEMPTING TO RE-LIGHT
THE PILOT.
5. Press On/Off button on remote control again to
start ignition sequence.
6. If it will not operate, follow the instructions
“Turning Off” section and call your service
technician or gas supplier.
TURNING OFF
1. Press the On/Off button on the remote control.
2. Turn off the external manual shutoff valve
supplied by installer and mounted adjacent to
the appliance.
3. Turn off all electric power to the appliance if
service is to be performed.