
12
© 2021 United States Stove Company
STOVE LOCATION
Plan for the installation of your stove. This includes
determining where the unit is to be installed, the
vent configuration to be used, framing and finishing
details, and whether any optional accessories (i.e.
blower, wall switch, or remote control) are desired.
Consult your local building code agency to ensure
compliance with local codes, including permits and
inspections. The following factors should be taken
into consideration:
•
This stove should have sufficient access for its safe
operation and maintenance.
•
Locate a position where the flue system of the
stove can be properly installed without damaging
the integrity of the building. e.g. cutting wall or
ceiling joist (example: load-bearing framing
members).
• When the appliance is installed directly on
carpeting, tile, or other combustible material
other than wood flooring, you must set the
appliance on a metal or wood panel extending
the full width and depth of the appliance.
•
Check stove and flue system clearance
requirements.
• Locate the stove where it can be accessed by a
gas supply line.
• Locate the stove in a large and open room that is
centrally located in the house. This will optimize
heat circulation and comfort.
•
The flow of combustion and ventilation air must
not be obstructed.
• Minimum clearances to combustibles, side-
wall, ceiling, woodwork, and windows must be
maintained.
• This stove may be installed along a wall, across a
corner, or use an exterior chase. Refer to the figure
below for suggested locations.
•
The location should be out of high traffic areas
and away from furniture and draperies due to
heat from the appliance.
• Never obstruct the front opening of the stove.
• Do not install in the vicinity where gasoline or
other flammable liquids may be stored.
• Vent pipe routing. See the Venting section found in
this manual for allowable venting configurations.
• These units can be installed in a bedroom. See
National Fuel Gas Code ANSI Z233.1/NFPA 54
(current edition), the Uniform Mechanical Code
(current edition), and Local Building Codes for
specific installation requirements.
NOTE: If this unit is installed in a mobile home it
must be bolted securely to the floor with leg bolts.
NOTE: Stoves work without any electrical supply.
INSTALLATION INFORMATION
Summary of Contents for AG23
Page 47: ... 2021 United States Stove Company 47 NOTES ...
Page 48: ...48 2021 United States Stove Company NOTES ...
Page 49: ... 2021 United States Stove Company 49 NOTES ...
Page 77: ......