2-7
10.
Adjust height of patient surface to lowest level. (Refer to related
Safety Information
in the
Introduction
chapter of this manual.)
11.
Set lock-outs as required:
Refer to the
Lock-Out Menus
section
in the
Operating Instructions
chapter of this manual for
additional information.
Lock-out controls are located on the bed motion control panel located below the main control panel.
• Bed functions (raise / lower head, foot, bed, Trendelenburg, etc.):
-
Locate bed motion and side rail control lock-outs on bed motion control panel.
-
Press
Back
,
Knee
or
Up / Down
button to disable side rail functions as required. Padlock symbol
will illuminate to indicate lockout is engaged for each function.
-
Press
Bed Motion Lock
button to disable side rail and footboard functions as required. Padlock
symbol will illuminate to indicate lock-out is engaged.
• Air functions (rotation, pulsation, air adjust, warmer, percussion):
Rotation, pulsation, percussion and warmer will be deactivated when the
Lock-Out
menus are
accessed. Only pulsation will be automatically restored when the
Home
menu appears.
-
Press and hold hidden button located
above
Scale
button on control panel for
approximately ten seconds until
Diagnostics
menu appears.
-
Press
Lock
button.
-
Press
Yes
or
No
button to answer
Are You
Using the Positioning Packs?
If YES button is selected, the patient will receive the degree of rotation set in the rotation menu. If
NO button is selected, the patient will not receive over 20° angle of rotation, regardless of the angle
values previously entered in the rotation menu.
-
Press
Change
button to adjust the lock-out settings for air adjust, warmer, pulsation and
rotation.
-
Press
Next
Menu
button.
-
Press
Change
button to adjust the lock-out settings for percussion.
-
Press
Enter
button to save lock-out settings and return to
Home
menu.
-
Reactivate air adjust, warmer, pulsation and rotation, as required.
Hidden
Button
ON/OFF
SCALE
