Arjohuntleigh FLOWTRON UNIVERSAL, Service Manual

Page: 55 / 116

Flowtron Universal Service Manual Pump Repair
Issue 2 Chap 5
Sep 2009 SER0009 Page 17
16 Replacing the Mains/Power Fuses on the Power Supply PCB Assembly
WARNING: MAKE SURE THE REPLACEMENT FUSES ARE THE CORRECT TYPE AND
RATING, OR THE ELECTRICAL SAFETY OF THE PUMP MAY BE IMPAIRED.
Note: Always replace both fuses even if only one has “blown”.
16.1 Remove the rear case from the pump (Refer to Page 13, Section 10).
16.2 Un-clip the plastic cover on one of the fuseholders, and remove the fuse (Fig 42, Item 10).
16.3 Install the new fuse (Fig 42, Item 10) into the fuseholder, and clip the plastic cover onto the
fuseholder.
16.4 Repeat for the second fuse (Fig 42, Item 10).
16.5 Install the rear case onto the pump (Refer to Page 13, Section 11).
17 Replacing the Air Inlet Filter on the Compressor Assembly
17.1 Remove the rear case from the pump (Refer to Page 13, Section 10).
17.2 Using a pair of tweezers, remove the air inlet filter (Fig 42, Item 20) from the air inlet filter holder
(Fig 42, Item 30).
17.3 Push the new air inlet filter (Fig 42, Item 20) fully into the air inlet filter holder.
17.4 Install the rear case onto the pump (Refer to Page 13, Section 11).
Figure 42 - Replacing the Mains/Power Fuses and Compressor Air Inlet FIlter
Table 13 - Mains/Power Fuse and Compressor Air Inlet FIlter Parts List
Item Part Number Description Qty
10 507422 Fuse, 3.15A 20mm Type T, Spares Item 2
20 509317 Air Inlet Filter, Compressor Assembly 1
30 509320 Air Inlet Filter Holder 1
10
20
30