Arjohuntleigh FLOWTRON UNIVERSAL, Service Manual

Page: 23 / 116

Flowtron Universal Service Manual Testing
Issue 2 Chap 4
Sep 2009 SER0009 Page 1
CHAPTER 4
TESTING
1 Initialising the Pump
1.1 Make sure that NO garments are connected to either pump hose set assembly.
1.2 Plug the pump into an electrical outlet, and switch on.
1.3 The pump will first go through a self-test routine (Refer to Figure 11).
Figure 11 - LCD Display - Running Diagnostic
1.4 At the end of the self-test routine, the pump will “beep” and go into Standby mode, where it will
remain until required for use (Refer to Figure 12).
Figure 12 - LCD Display - Standby
2 Garment Recognition Test
2.1 Initialise the pump (Refer to Page 1, Section 1).
2.2 Connect a garment to each pump hose set assembly. Make sure the connectors click into place.
2.3 Make sure the connection and garment types are confirmed correctly on the display, as follows:
Note: There is a separate graphic for each hose set assembly, and each of these can be one of
a number of graphics to indicate the garment type (Refer to Table 3).
2.3.1 Figure 13 shows two single-chamber calf or thigh/calf garments connected to the
pump.
Figure 13 - LCD Display - Two Single-Chamber Calf or Thigh/Calf Garments Connected