HARDWARE INSTALLATION
35
RAID subsystem using the serial ATA cable included in your kit.
1. Connect the serial ATA cable to RAID subsystem serial ATA
connector. The serial ATA cable have two black connectors.
One is connected to the controller card or on-board serial ATA
connector. The other one is connected to the RAID subsystem
serial ATA connector.
• Step 8 Connecting RAID Subsystem to HOST SCSI Chan-
nel (ARC-6020)
There are two SCSI connectors are provided on the back of the
RAID subsystem for connecting the array to SCSI HOST Adapter.
Installation of the RAID subsystem is very similar to the installa-
tion of a standard SCSI drive Refer to your system and/or SCSI
host adapter manual for additional installation procedures that
may apply to your system or host adapter. By installing HOST
SCSI Channel and RAID subsystem using the SCSI cables included
in your kits.
Follow these steps to connect HOST SCSI Channel and RAID sub-
system:
1. The RAID subsystem is the last internal device in the
daisy-chained configuration.
For 6020 (80219)
Plug the SCSI LVD cable supplied with the SCSI card kit
to the SCSI adapter internal connector and the last device
connector to the RAID subsystem SCSI-IN connector.
For 6020 (IOP321 CPU)
ARC-6020 has build-in terminator and it can be disabled and
enabled. Therefore, when terminator not require to be plug-in
if this feature set at enable.
a. Add the other SCSI LVD cable supplied with the RAID sub
system kit to its SCSI- OUT connector and place an LVD
SCSI active terminator on the other end of this connector.
2. The RAID subsystem is the first internal device in the
daisy-chained configuration.
a. Plug the SCSI cable supplied with the RAID subsystem kit to
Summary of Contents for ARC-5030 Series
Page 11: ......
Page 74: ...LCD CONFIGURATION MENU 74 Figure 4 8 4 2 ARC 6020...
