98
GC045A
3. Install the pinion shaft and secure with a new 48 mm
lock collar. Tighten to 125 ft-lb.
CC890
4. Place a punch on the edge of the lock collar in the oil
gallery area; then using a hammer, stake the lock col-
lar to ensure that the collar will remain securely
tightened.
CC891
5. Install the pinion housing.
Removing/Installing Axle Seal
NOTE: This procedure can be performed on a rear
gear case.
1. Remove the seal using a seal removal tool.
GC066
2. Using a press, remove the bearing.
CC900
3. Using a press, install the new bearing into the hous-
ing.
CC901
NOTE: Prior to installing the seal, apply High Perfor-
mance #2 Molybdenum Disulphide Grease to the seal
outside diameter.
4. Using an appropriate seal installation tool, evenly
press the seal into the cover bore until seated.
CAUTION
Make sure the tool is free of nicks or sharp edges or the
seal will be damaged.
Manual
Table of Contents
