51
MD1018
5. Install the clutch shoe assembly on the crankshaft;
then install the flange nut (left-hand thread) (coated
with red Loctite #271). Tighten to 147 ft-lb.
NOTE: The flat side of the flange nut should be
directed towards the clutch shoe.
6. Install the one-way clutch making sure that the green dot or
the word OUTSIDE is directed away from the crankcase.
MD1286
B. Clutch Cover
C. Fixed Drive Face
D. Movable Drive Face
NOTE: Steps 1-6 in the preceding sub-section must
precede this procedure.
7. Install two alignment pins and place the clutch cover
gasket into position. Install the clutch cover.
MD1115
8. Tighten the clutch cover cap screws to 8 ft-lb.
MD1117
9. Install the air intake plate. Apply red Loctite #271 to
the threads of the three Phillips-head cap screws;
then install and tighten securely.
MD1342
10. Place the driven pulley assembly into position and
secure with the nut (threads coated with red Loctite
#271). Tighten to 147 ft-lb.
MD1068
KC134
CAUTION
Care must be taken when installing the flange nut; it has
“left-hand” threads.
Manual
Table of Contents
