19
KC142A
3. Remove the nut securing the movable drive face to the clutch
shaft; then remove the movable drive face assembly being
careful not to let the roller fall out. Account for a bushing.
KC127
KC128
4. Thread a cap screw from the V-belt cover into the
driven pulley fixed face and push the movable face
open allowing the V-belt to drop down between the
pulley faces approximately 3/4 in.
KC137
5. Pinching the V-belt together in front of the driven
pulley, pull it forward and outward off the clutch
shaft; then remove it from the driven pulley.
KC136
6. Inspect the faces of the drive and driven pulleys for
scoring, pitting, cracks, or grooving; then clean any
dirt and debris from the V-belt housing and cover.
INSTALLING
1. Place the V-belt onto the driven pulley making sure
the arrows point in the direction of rotation; then
pinch the belt together in front of the driven pulley
and place it over the clutch shaft.
KC135
KC131
2. Install the bushing over the clutch shaft; then install
the movable drive face assembly on the clutch shaft.
Manual
Table of Contents
