120
CLEANING AND INSPECTING
NOTE: Whenever a part is worn excessively, cracked,
or damaged in any way, replacement is necessary.
1. Clean all rear body panel components with warm
soap and water.
2. Inspect side panels and rear body panel for cracks
and loose rivets.
3. Inspect threaded areas of all mounting bosses for
stripping.
4. Inspect for missing decals.
INSTALLING
1. Place the rear body panel/fender in place on the
ATV; then secure with the cap screws on the side
frame and the rear rack assembly. Tighten all fasten-
ers securely.
KC317A
KC320A
2. Connect the light connectors and secure to the frame;
then install the battery, starter relay, and auxiliary
brake. Connect all wiring making sure to connect the
positive cables first.
KC279
KC322
3. Secure the rear fenders to the footwells and tighten
the nuts securely.
4. Install the side panels and seat.
Seat
REMOVING/INSTALLING
1. To remove the seat, lift up on the latch release
(located at the rear of the seat). Raise the rear of the
seat and slide it rearward.
2. To lock the seat into position, slide the front of the
seat into the seat retainers and push down firmly on
the rear of the seat. The seat should automatically
lock into position.
Manual
Table of Contents
