41
FI549
8. Using the Magneto Rotor Remover Set, break the
rotor/flywheel loose from the crankshaft; then remove
the puller and crankshaft protector and remove the
rotor/flywheel.
FI550
9. Remove the flywheel key from the crankshaft; then
remove the starter clutch gear.
FI551A
10. Remove starter idler gears and their respective
shafts; then remove the starter motor. Account for an
O-ring on the starter drive housing.
FI555
G. Shift Shaft
H. Drive Gear
NOTE: Steps 1-10 in the preceding sub-sections
must precede this procedure.
11. Remove the shift shaft noting a washer on each end;
then remove the cap screw securing the gear shift
cam plate and remove the plate from the shaft.
FI559
12. Remove the shift detent cam arm and spring.
FI560
13. Remove the snap ring securing the output drive gear
to the output shaft and remove the gear noting that
the hub flange is directed toward the crankcase.
Manual
Table of Contents
