67
KC195A
KC267
NOTE: Some oil seepage may occur when installing
the oil pressure gauge. Wipe up oil residue with a cloth.
3. Warm up the engine to normal operating temperature
(cooling fan cycling); then increase engine RPM to
3000 RPM. The oil pressure must read 0.6-0.7 kg/cm
2
(8.5-17 psi).
KC268
KC269
NOTE: If the oil pressure is lower than specified,
check for low oil level, defective oil pump, or
restricted oil cooler.
NOTE: If the oil pressure is higher than specified,
check for clogged oil passage, clogged oil filter, or
improper installation of the oil filter.
Liquid Cooling System
When filling the cooling system, use premixed Arctic Cat
Antifreeze. While the cooling system is being filled, air
pockets may develop; therefore, run the engine for five
minutes after the initial fill, shut the engine off, and then
fill the cooling system to the bottom of the stand pipe in
the radiator neck.
RADIATOR
Removing
1. Drain the coolant at the engine.
2. Remove the front rack and body panel (see Steer-
ing/Frame/Controls section).
3. Remove the upper and lower coolant hoses; then
remove the fill hose and air bleed hose.
4. Remove the cap screws securing the radiator to the
frame.
5. Disconnect the fan wiring from the main wiring har-
ness; then remove the radiator/fan assembly and
account for the grommets and collars.
6. Remove the fan/fan shroud assembly from the radiator.
Cleaning and Inspecting
NOTE: Whenever a part is worn excessively, cracked,
or damaged in any way, replacement is necessary.
1. Flush the radiator with water to remove any contami-
nants.
2. Inspect the radiator for leaks and damage.
3. Inspect all hoses for cracks and deterioration.
4. Inspect all fasteners and grommets for damage or
wear.
Installing
1. Position the fan/fan shroud assembly on the radiator;
then secure with existing hardware.
2. Place the radiator with grommets and collars into
position on the frame; then install the cap screws.
Tighten securely.
3. Install the upper and lower coolant hoses, fill hose,
and air bleed hose; then secure with hose clamps.
CAUTION
After operating the ATV for the initial 5-10 minutes, stop
the engine, allow the engine to cool down, and check
the coolant level. Add coolant as necessary.
Manual
Table of Contents
