ARAG IBX100 4679004, Installation - Use - Maintenance

Page: 35 / 60

35
DATA AND SETTINGS
12.3 Info and alarms
From this menu you can enable alarm visual and acoustic notifications when the related event occurs.
Alarm enabled
/
Alarm disabled
.
For the procedure to be followed when an alarm occurs, please refer to par.
16.3 Error messages
.
1
2
Fig. 71
APPLICATION RATE ALARM
1
Alarm active when user changes the application rate during treatment ( par. 15.1 ).
TANK ALARMS
2
One of the two alarms activates if tank (minimum or maximum) level is not within the
set values ( par.
11.8
).
5
6
3
4
Fig. 72
FLOWMETER ALARMS
3
Outside the range set in the
Minimum flowrate
/
Maximum flowrate
menus ( par.
11.2 Flowmeters
), the VT triggers an alarm.
NOZZLE ALARMS
4
Outside the range set in the
Minimum pressure
/
Maximum pressure
menus ( par.
11.5 Nozzle data
), the VT triggers an alarm.
5
Enable/disable nozzle wear check and set the tolerance threshold in point
6
.
6
Set the acceptable threshold: the VT compares the effective rate read by the flowmeter
and the one calculated by the pressure sensor.
When the difference between the two rate values exceeds the set percentage the alarm
is triggered.
7
8
10
9
Fig. 73
ADJUSTMENT ALARMS
7
Alarm is activated with main control ON, but rate at zero.
8
Alarm is activated with main control ON with machine stopped.
9
Alarms are activated if pressure, or speed, do not reach the set limit values ( par.
12.2
).
10
Alarm is activated if the output (l/ha or GPM) is different from the set application rate
( par. 12.1 ).
11
12
13
14
Fig. 74
RPM ALARMS
11 Outside the range set in the
Minimum rotation speed
/
Maximum rotation speed
menus ( par.
11.7 Rev counter
), the VT triggers an
alarm.
SELETRON ALARMS
Alarms relating to Seletron valves (Basic settings, chap .
10
):
12
Alarm is activated when (one or more) spraying points do not respond.
13
Alarm is activated when the input voltage on one or more spraying points is too low.
HARDWARE ALARMS
14 Enable / disable ECU hardware status alarm.