43
SELETRON CONNECTION
Fig. 87
The products are supplied with valve installation
instructions.
Make sure the device is correctly fitted and push
it until locking it. When the cable is inserted in the
connector, the Seletron is sealed.
To avoid damaging the internal components, make
sure that when using or cleaning the system the
connectors are not bare or inserted incorrectly.
CONNECTION SEQUENCE FOR SINGLE AND TWIN SELETRON DEVICES
CONNECTOR 1
NOZZLE A
NOZZLE B
Fig. 88
Connect all Seletron devices in sequence, from left to right until the end of the boom.
CONNECTION SEQUENCE FOR FOURFOLD SELETRON DEVICES
CONNECTOR 1
CONNECTOR 2
NOZZLE A
NOZZLE C
NOZZLE B
NOZZLE D
1
2
Fig. 89
1
Connect in sequence
ONLY SELETRON NOZZLE HOLDERS A AND B
, from left to right until the end of the boom (
connector 1
2
Start again from the beginning: this time connect
SELETRON NOZZLE HOLDERS C AND D
, from left to right until the end of the boom (
connector 2
).
13.1
ID Reset
Allows to reset the identification numbers of all saved Seletrons, before repeating the pairing procedure (
chap
).
TO PREVENT SYSTEM MALFUNCTIONS, THIS OPERATION MUST BE CARRIED OUT ONLY IF STRICTLY NECESSARY
2
1
Fig. 90
Press key
1
to delete identification numbers.
Press key
2
to confirm
.
At the end of the reset procedure, DISCONNECT ALL SELETRONS
and start a new pairing procedure (
chap
).
