55
JOB FUNCTIONS
"FENCE NOZZLE" FUNCTION ENABLED
This function provides for the installation of specific nozzles at the end of the boom, which allow spraying of areas that traditional nozzles cannot reach
because of the boom dimensions (e.g. Fences). The activation does not interrupt the supply of the other boom nozzles. The procedure for connection
as well as detection of Seletrons and "Fence" nozzles is carried out as follows: first connect all the boom nozzles, then the left "Fence" nozzle and the
right "Fence" nozzle. By setting reference pressure and flowrate for the "Fence" nozzle, it is possible to check the supply of all the nozzles according
to the set application rate. The spraying range of the "Fence" nozzle is not included in the calculation of the applied area.
Fig. 113
Fence zone
If this function is enabled under implement basic settings (
chap
) it is
possible to select standard or special nozzles: the activation of "Fence"
nozzles does not interrupt the supply of the other boom nozzles.
Nozzle selection modes are variable (they vary based on the Auxiliary
Input connected to the VT). Following are some examples.
END NOZZLES:
CORRESPONDING ICON ON "HOME" SCREEN
Special nozzle
LEFT
ENABLED
Special nozzle
RIGHT
ENABLED
Special nozzle
LEFT
DISABLED
Special nozzle
RIGHT
DISABLED
EXAMPLE OF NOZZLE SELECTION WITH SWITCH PANEL
• Activation of the left-hand special nozzle (when looking at the boom from behind)
Press switch once to the left, the left
"Fence" nozzle activates. The LH
LED blinks.
• Activation of the right-hand special nozzle (when looking at the boom from behind)
Press switch once to the right, the
right "Fence" nozzle activates. The
RH LED blinks.
• Deactivation of the left-hand special nozzle (when looking at the boom from behind)
Press switch once to the right, the
left "Fence" nozzle deactivates. The
LH LED stops blinking and will stay
on steadily.
• Deactivation of the right-hand special nozzle (when looking at the boom from behind)
Press switch once to the left, the right
"Fence" nozzle deactivates. The RH
LED stops blinking and will stay on
steadily.
EXAMPLE OF NOZZLE SELECTION WITH JOYSTICK
Seq. 1 R
Seq. 2 L
Seq. 1 L
Seq. 2 R
The operation is similar to the one of the sequential switch panel just described.
The functions related to the activation of nozzles are in the "Main" page.
For all the details about use refer to the instructions supplied with the joystick.
