ARAG 4679004, Installation, Use And Maintenance Manual

Page: 20 / 76

20
IMPLEMENT SETTINGS
11.1
Home > data and settings > implement settings > Boom
1
Indicate the number of boom sections.
2
Indicate the distance between spraying points (nozzle holders).
3
Indicate the number of spraying points (nozzle holders) installed on each boom section.
3a
Repeat the setup for each section ( Fig. 37 ) .
3b
It allows to enable/disable specific boom sections. Repeat the setup for each section, by disabling the disconnected outputs.
4
The displayed number of valves / Seletron that can be managed depends on the type of VT connected to the system.
The VT could be able to manage just a limited number of sections, therefore, should it not be possible to manage all nozzle holders individually, the
VT will group them so as to fully exploit the number of permitted sections.
5
Displays the type of installed end nozzles (Basic settings, chap. 10).
1
2
*
3
4
5
Fig. 36
3a 3b
Fig. 37
Depending on your programming, both the total number of spraying points and the boom width value will change, displayed in
Fig. 36.
*
SELETRON SYSTEM:
The operator may choose the way
in which the boom is subdivided into
different sections: this is done in order to
act on the corresponding control when
closing sections manually.
With automatic management, instead, the
computer acts on:
- each single Seletron (Seletron mode)
- each single section (valve mode)
VALVE
SECTION
1
VALVE
SECTION
2
BOOM LENGTH
Fig. 38
Quits without confirming the
changes
Saves the changes
Cancel
Exits
Confirm
Goes back to previous menu,
or scrolls the pages of a menu
(previous page)
Scrolls the pages of a menu
(next page)
Goes back to main screen
Saves the changes to current
page