ARAG 46742DX1, Installation, Use And Maintenance Manual

Page: 18 / 96

18
8.5 Connecting the sensors
Fix the connectors to the relevant functions according to the initials indicated in your assembly general diagram (par. 6.1).
Harness cables are marked with a symbol denoting their functions:please see the table for correct harness instructions.
Use ARAG sensors: use of unsuitable sensors not provided by ARAG automatically voids the warranty.
ARAG is not liable for damage to the equipment, persons or animals caused by failure to observe the above instructions.
ITEM
CONNECTION
PRIMARY
ALTERNATIVE
CONNECTION
M
Pressure sensor --
f
Flowmeter --
t
Filling flowmeter Pump Protector
X
RPM sensor Pump Protector
The "Pump Protector" sensor (code 4664000.100) when connected to the computer, detects and signals breakage of the pump diaphragm or indicates
when the oil drops below its minimum level.
The preferred sensor input is always marked with an "X" on the harness; if this input is not available, use the secondary input marked "T".
WARNING:
the secondary connection “T” shall be used only if connection "X" is already occupied by another sensor.
Do not use the secondary input "T" if no sensor is connected to the "X" input otherwise the computer will not be able to
acknowledge the Pump Protector sensor.
- The products are supplied with the sensor installation instructions.
The following speed sensors can also be used as RPM sensors:
• inductive speed sensor (
code 467100.086);
• magnetic speed sensor (
code 467100.100).
- Connection of:
• flowmeter;
• pressure sensor;
• Pump Protector;
• filling flowmeter;
• RPM sensor.
All ARAG sensors use the same type of connector. Connect the sensor connector to the relevant harness; make sure it is correctly fitted and push it
until locking it.
Fig. 24
Fig. 25
8.6 Connecting the cameras
Bravo 400 can be connected to one or two cameras code 46700100 (to be purchased separately) using the suitable cables specified on the ARAG
catalogue.
Connect the connector to the monitor (connection points at par. 6.2) and bring the other cable end to the camera: properly fit the ring nut and turn it
clockwise until it locks.
INSTALLATION