7
1
RiSkS and pRotectionS befoRe aSSembly
All installation work must be done with battery disconnected, using suitable tools and any individual protection equipment
deemed necessary.
Use ONLY clean water for treatment tests and simulations: using chemicals during simulated treatment runs can seriously injure
persons in the vicinity.
2
bRavo dSb
ARAG has designed and manufactured a diagnostics system for Bravo series computers and the systems to which they may be connected.
BRAVO DSB
(code 467003)
provides reliable diagnostics of computer, control unit or the whole system so as to enable the resolution of any potential
problems experienced with the BRAVO DSB system.
3
intended uSe
The device you have purchased is a computer which, when connected to a valve or suitable control unit, makes it possible to control all phases of
treatment in agricultural applications directly from the cabin of the agricultural machine in which it is installed.
BRAVO 400 is a satellite navigator which can be used for agricultural purposes thanks to its GPS receiver.
BRAVO 400 is not a road navigator and should only be used on agricultural land.
This device is designed to work on agricultural machinery for crop spraying applications.
The machine is designed and built in compliance with EN ISO 14982 standard (Electromagnetic compatibility - Forestry and
farming machines), harmonized with 2004/108/EC Directive.
4
pRecautionS
• Do not aim water jets at the equipment.
• Do not use solvents or fuel to clean the case outer surface.
• Do not clean equipment with direct water jets.
• Comply with the specified power voltage (12 Vdc).
• If doing arc-welding, disconnect the connectors from BRAVO 400 and disconnect its power cables.
• Only use ARAG genuine spare parts and accessories.
• Bravo 400 can control the hydraulic valves that open and close the job boom.
The computer does not feature emergency stop devices: the manufacturer must provide all necessary safety devices for the
hydraulic boom control.
Any time the hydraulic boom section is opened or closed the computer emits an acoustic signal and the display shows the
relevant indication. The manufacturer should also provide acoustic and optical warnings in the vicinity of the boom.
5
contentS of the package
The table below shows the components you will find inside the BRAVO 400 computer package:
Fig. 1
Legend:
1
Bravo 400
2
User's guide
3
Control unit (RCU)
with relevant harnesses
3a
Connection cable
to oil-hydraulic assembly
3b
Connection cable
to control unit
3c
Connection cable
to power sensors
3d
Connection cable to monitor
4
SD memory card
5
Mounting kit
6
Drive for SD memory card
7
GPS receiver
8
Receiver
support
9
Connection cable
to switches panel / monitor
10
Connection cable
to GPS receiver
11
a
Seals for section valve
connectors
11
b
Seals for oil-hydraulic valve
connectors
12
Power connector
INTRODUCTION
Summary of Contents for 46742DX1
Page 6: ...Notes 6...
Page 94: ...Notes 94...
