63
USE
12.9
Spraying a field
Fig. 217
Let's consider to wish to spray field by parallel lines, but only after spraying field borders.
• Switch Bravo 400 on (par 9.2).
After self-diagnosis routine, system asks if you wish to continue a previous job (Fig. 217).
Press
ESC
to start a new spraying job.
• Select driving mode you wish to use during spraying job: execute function
(par. 13.1.4).
• Select or set the spraying to perform with the suitable function
(par. 13.1.1 - 13.1.2).
• Set the tank level with the suitable function
(par. 13.1.9).
• Set at the beginning of field to spray (Fig. 218).
• Operate the switch for the main control valve to start spraying.
• Start driving along field border. During this path, message
Mark A?
is displayed
Fig. 218
maRking pointS a and b
• While driving field border you will mark two points A and B
(as described under par. 13.2.2 - function
).
This operation is essential for Bravo 400 to guide you,
during spraying, on tracks parallel to the reference one obtained marking
points A and B.
We recommend that you mark A and B at the ends of a straight
length as long as possible and while vehicle is moving: the
longer the marked length across points A and B, the lower the
error caused by your deviation while driving.
Fig. 219
• Once straight line A/B (
t0
) is tracked, the whole field could be sprayed
along tracks parallel to it (Fig. 219), following the reference tracks that will
be displayed (Fig. 220).
Fig. 220
Summary of Contents for 46742DX1
Page 6: ...Notes 6...
Page 94: ...Notes 94...
