Aquasafe WSL25 Pro, Instruction Manual

Page: 11 / 153

2.2 Battery Removal
It may be desired to remove the batteries or replace them at the end of their life. To replace or
remove the batteries first ensure the switch on the rear of the carry case is in the off position then
remove the screw on the left side of the docking station.
Next lift up the hinged panel from left to right which will reveal the two batteries. To remove the
batteries lift each battery out carefully and disconnect the wires from the battery terminals.
Replacement is the reversal of removal. Ensure that the brown wires go to the red terminals and
that the blue wires go to the black terminals. Failures or damage arising due to incorrect
connection of the wires will invalidate the warranty. It is also advised that batteries are only
removed if absolutely necessary.
2.3 Battery Charging
It is recommended to charge the battery fully prior to use. To do this remove the power supply
unit from the kit and connect it to the charging connection on the rear of the carry case, screwing
firmly into position. Plug the other end into a 90 - 240V AC outlet, then switch on the unit via the
on/off switch on the rear of the case.
The indicator on the charger will illuminate red, orange or green. The states indicate battery
condition as follows:
Red: discharged.
Orange: Partially charged.
Green: Fully charged.
To charge the battery from a discharged state takes approximately 4-6 hours.
If desired the incubator can be used whilst the battery is being charged however the battery will
charge at a lower rate.
Note: The battery charger comes complete with an IEC C19 to UK mains lead. Replacement leads
must be of the same type with a sealed plug and maximum cable length of 2 metres, and must
carry the CE mark.
Screw
Batteries