APCON, Inc.
58
A54-3144-XR • Rev B
Chapter 5. Configure the chassis
ACI-3144-XR Chassis User Manual
About
To access the
Switch Information
screen, press
DOWN
to scroll through the Main Menu.
Highlight
the
About
sub-menu, then press
ENTER
. The following screen is displayed:
The following table describes the information listed on the
Switch Information
screen.
Information
Description
Name
Name you specify for the chassis using W
EB
XR or CLI. The default is
Unnamed
. To change the chassis name, use either W
EB
XR or CLI (see
Model
Model number for the chassis.
Software
Current version number of software installed on the Active Controller.
IP
n
IP address configured for the chassis.
If the IP address is not configured, the display is “n/a”.
Netmask
n
Subnet mask configured for the chassis. The default is
255.255.255.0
. If Netmask2 is not configured, the display is “n/a”.
Gateway
n
Network gateway address for the chassis. The default is no gateway
(
0.0.0.0
). If Gateway2 is not configured, the display is “n/a”.
MAC
n
MAC address of the LAN1 or LAN2 port.
BP Serial
Backplane serial number.
Act Model
Active Controller—model number.
Act Serial
Active Controller—serial number.
Act Date
Active Controller—manufacture date.
Stby FW
Current version of software installed on the Standby Controller.
Stby Model
Standby Controller—model number.
Stby Serial
Standby Controller—serial number.
Stby Date
Standby Controller—manufacture date.
Stby IP n
IP addresses for the Standby Controller. If the Standby Controller’s LAN
interfaces are not configured, the display is “n/a”.
