ANGELUS SANITARY CAN MACHINE COMPANY
SERVICE NOTICE
1 of 3
10/11/99-18059001
Model 140S and 180S Seamers
Cover Feed Systems
Subject:
Feed Turret Cap Pusher height in relation to Inner Cap Guide Rail.
Description:
Cap Pushers mounted to the Feed Turret
guide ends through Cap Guide Rails from
Separator Assemblies to the Can and End
Makeup area. In order to perform properly,
Cap Pushers must be located higher than
the top of the Inner Cap Guide Rail by no
less than .015 of an inch (,38mm).
This dimension is controlled by the Bearing
Retainer mounted to the Upper Turret
Housing.
Procedure:
(Use Cross Section Drawing on the next page to
identify parts.)
Measure from Cap Pusher to Rail surface.
1. Move the Cap Pusher to the open area of the
Cap Guide Rail Bracket.
2. Measure from the Cap Pusher down to the Inner Cap Guide Rail surface. See photo.
As an example, let say, the top of the
Cap Pusher is even with the Rail surface.
3. Pull out the Separator Drive Shaft located
under the Cover inside the Housing Ser-
vice Door. It is advisable not to rotate the
Seamer with this Shaft removed to main-
tain Separator Timing.
4. Remove fasteners to lower the Feed
Turret Hub.
5. Install Feed Turret Installation and
Removal fixture160S816.
6. Use an adjustable Spanner to loosen the
Cap Feed Turret Screw.
(LEFT HAND THREADS).
7. Carefully lower the Feed Turret, Screw
and Ball Bearing down onto the fixture.
8. Support the Gassing Manifold and remove
This is the Bearing Retainer that controls the
the M10 Hex. Hd. Screw that locates the
height of the Feed Turret
Manifold on the Bearing Retainer. Lower
the Manifold, Manifold Ring Assembly and Compression Springs. Manifold removal will
expose the targeted Bearing Retainer.
