ANGELUS SANITARY CAN MACHINE COMPANY 10/12
SERVICE NOTICE
18043001
NOTE:
Installation of this Ball Bearing may
become difficult if the Gear is not level.
To simplify this assembly, install four long
M10 screws, through tapped holes, directly
below the Gear and use them to level out
the Gear. This will aid in aligning the
Column with Gear. Once installed, use a
thread adhesive on screw threads to insure
against loosening.
C.
Install Column Support Key first then
Column Support with O-Ring, eight
M10-1.5 X 40mm Hex. Hd. Screws using
thread adhesive, and use the Locknut
Spanner to secure the Column with the
Bearing Locknut & Lockwasher.
27L647 =
Column Support Key
Place Support Key up first, then the Column Support
64S817 =
Column Support
9S815 =
O-Ring
5L416 =
Bearing Locknut
6L416 =
Bearing Lockwasher
78L416 =
Locknut Spanner
Retainer w/V-Ring & Oil Seals
4.
Complete Assembly of Discharge Table
A.
Install Discharge Bearing Retainer, using
a liquid gasket material on mating surfaces,
lubricate Oil Seals, lubricate V-Ring and
install ten M10 -1.5 X 40mm Hex. Hd. Screws.
63S817 =
Discharge Bearing Retainer
65S815 =
Oil Seals
64S815 =
V-Ring
NOTE:
Be certain that O-Ring 12S815 is in place
before securing the Bearing Retainer
