ANGELUS SANITARY CAN MACHINE COMPANY 5/12
SERVICE NOTICE
18043001
4.
Release the Discharge Turret Gear from
the Turret Hollow Shaft
A.
Take out eight M10-1.5 X 40mm Soc. Hd.
Screws from the Bearing Retainer.
62S817 =
Bearing Retainer
21S844 =
Discharge Turret Hollow Shaft
Bearing Retainer
B.
Remove the Bearing Retainer and Ball
Bearing located up inside the Gear.
62S817 =
Bearing Retainer
113S816 =
Ball Bearing
NOTE:
Do not use a pry bar to break the Bearing
Retainer loose. Scratches or dents in the
Base bore will impair proper O-Ring seat
after the Column Support is assembled.
Seal Pullers or Coil Spring Hooks have
proven to be successful in removing the
Retainer and Ball Bearing.
Ball Bearing & Bearing Retainer Removed
5.
Discharge Turret Gear removal
A.
Place a sleeve measuring 3" +.010, -.000 I.D. X
NOTE:
4.62" +.000, -.020 O. D. X .500" thick up onto
Removal of the sleeve
the Column and inside the Turret Gear bore
will be easier if two M6-1
contacting the Hollow Shaft.
tapped holes were put in
the end of the sleeve for
11S844 =
Column W/ Insert 54L826
a puller attachment.
9S823 =
Discharge Turret Gear
21S844 =
Discharge Turret Hollow Shaft
B.
Install the Bearing Locknut onto the Column.
