ANGELUS SANITARY CAN MACHINE COMPANY
SERVICE NOTICE
9/9/99-18033004
6 of 14
Rev. 1 - 9/9/99
AMBER PILOT LIGHT WHICH INDICATES THAT OIL IS PRESENTLY BEING SENT TO THE
BOOST
JUNCTION BAR LOCATED ON THE DRIVE CASE ON TOP OF THE UPPER TURRET
HOUSING
*OIL BOOST ON LIGHT continued;
AND NOT TO EITHER THE SEAMER BASE OR THE TRABON PUMP RESERVOIR, BY THE
FOLLOWING LIGHT STATES.
FLASHING:
SEAMER OIL BOOST IS IN PROGRESS.
ILLUMINATED:UNDEFINED.
*TRABON REFILL ON LIGHT
AMBER PILOT LIGHT WHICH INDICATES OIL IS BEING DIVERTED FROM THE SEAMER BASE
THROUGH THE FILTRATION SYSTEM AND TO THE TRABON RESERVOIR TO REFILL IT, BY
THE
FOLLOWING STATES.
ILLUMINATED:TRAB0N REFILL IS IN PROGRESS
*FILTRATION PUMP MOTOR STARTER OVERLOADS. N.C. EUTECTIC ALLOY
THERMAL TYPE OVERLOAD SWITCHES, LOCATED WITHIN THE OIL FILTRATION PUMP MO-
TOR STARTER, WHICH OPEN IF THE CURRENT TO THE PUMP MOTOR SHOULD BECOME
EXCESSIVE FOR ANY REASON.
*HIGH OIL PRESSURE SWITCH - N.C.
PRESSURE SWITCH LOCATED IN THE OIL FILTRATION SYSTEM PUMP OUTLET PIPING. THIS
SWITCH IS ADJTUSTABLE AND IS FACTORY SET TO OPEN IF THE OIL PRESSURE AT THE
PUMP OUTLET SHOULD REACH 75 PSI.
*HIGH OIL PRESSURE SWITCH - N.C. CONTINUED;
THIS SWITCH WILL ACTUATE IF THE OIL FILTRATION SYSTEM IS ALLOWED TO OPERATE TO
THE POINT WHERE THE FILTERS BECOME DIRTY AND ARE NOT REPLACED.
AT ACTUATION THE CHANGE FILTERS LIGHT WILL BECOME ILLUMINATED.
*WARNING OIL PRESSURE SWITCH N.C.
PRESSURE SWITCH LOCATED IN THE OIL FILTRATION SYSTEM PUMP OUTLET PIPING. THIS
SWITCH IS FACTORY SET TO OPEN IF THE OIL PRESSURE AT THE PUMP OUTLET SHOULD
REACHES 65 PSI.
THIS SWITCH WILL ACTUATE WHEN THE OIL FILTRATION SYSTEM IS ALLOWED TO OPER-
ATE
TO THE POINT WHERE THE FILTERS BECOME DIRTY AND REQUIRE REPLACEMENT.
AT ACTUATION THE CHANGE FILTERS LIGHT WILL FLASH.
*OIL FLOW SWITCH - N.O.
THE THERMAL DISPERSION SWITCH CLOSED BY OIL FLOW FROM THE FILTRATION SYSTEM
PUMP. THIS INPUT TO THE PLC IS AN INDICATION THE FILTRATION SYSTEM IS OPERATING
NORMALLY AND IS USED AS A LATCH TO MAINTAIN THE OIL FILTER SYSTEM MOTOR
STARTER. (LOSS OF FLOW STOPS THE PUMP)
THIS SWITCH IS FACTORY SET TO OPEN DURING OPERATION SHOULD THE OIL FLOW FALL
BELOW A RANGE OF 0.2 TO 0.25 GPM.
*OIL DIVERTER SOLENOID VALVE.
3 PORT 2 POSITION, SOLENOID OPERATED, SPRING RETURNED, DIRECTIONAL CONTROL
VALVE WITH 24VDC (120VAC OPTIONAL)
