C
1
3
9
6
154
01
.f
m
- 21 -
English
IT
GB
DE
FR
ES
To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Remove the knob unit (B).
4 - Undo the screws (C) and remove the control
panel (D).
5 - Undo the screws (E) and extract the cap (F).
6 - Pull off the cone (G).
7 - Clean the cone (G) and its seat.
8 - Coat the cone with grease (G), fit it in its seat
and turn it a few times.
9 - Pull off the cone (G) to remove the excess
grease.
10 - Replace the cone (G), the cap (F), the control
panel (D) and the knobs (A-B).
Before carrying out any replacement procedure, ac-
tivate all the safety devices provided and decide
whether staff at work and those in the vicinity
should be informed. In particular, turn off the gas
supply tap and prevent access to all devices which
might cause unexpected health and safety hazards
if turned on. If work parts have to be replaced, use
original spare parts only. The manufacturer de-
clines all responsibly for injury or damage to
components due to the use of non original
parts, or extraordinary work on the appliance which
may modify the safety requirements without the
manufacturer's authorisation. When ordering com-
ponents, follow the instructions provided in the
parts catalogue.
To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Open the hatch (A).
3 - Undo the screw (B).
4 - Unscrew the nozzle (C) and replace it with the
one suitable for the type of gas in use (see table
at back of manual).
5 - Tighten the screw (B).
6 - Close the door (A) when the operation is com-
plete.
GREASING THE GAS TAP
REPLACING PARTS
9
RECOMMENDATIONS FOR REPLACING PARTS
REPLACEMENT OF THE BURNER NOZZLE
IDM-39615401900.tif
C
B
E
F
G
A
D
IDM-39615402000.tif
A
B
C
Summary of Contents for 191PD1G
Page 2: ......
