AMX Modero Viewpoint MVP-5200i, Operation/Reference Manual

Page: 167 / 202

Programming
159 MVP-5200i Modero Viewpoint Widescreen Touch Panel
Intercom Commands
The following is a list of Intercom Commands:
Intercom Commands
^MODEL?
Sets model name.
Panel model name. If the panel supports intercom hardware it will respond with its model
name as shown in the response below. Older hardware or newer hardware that has inter-
com support disabled with not respond to this command.
Syntax:
SEND_COMMAND <DEV>,"'^MODEL?'"
Variables:
None.
Example:
SEND_COMMAND TP1,"'^MODEL?'"
Panel response string if intercom enabled:
^MODEL-MVP-8400i
^ICS-
Intercom start.
^ICS-<IP>,<TX UDP port>,<RX UDP port>,<initial mode>'"
Intercom start. Starts a call to the specified IP address and ports, where initial mode is
either 1 (talk) or 0 (listen) or 2 (both). If no mode is specified 0 (listen) is assumed. Please
note, however, that no data packets will actually flow until the intercom modify command is
sent to the panel.
Syntax:
SEND_COMMAND <DEV>,"'^ICS-<IP>,<TX UDP port>,<RX UDP
port>,<initial mode>'"
Variables:
IP = IP Address of panel to connect with on an Intercom call.
TX UDP port = UDP port to transmit to.
RX UDP port = UDP port to receive from.
initial mode = 0 (listen) or 1 (talk) or 2 (handsfree). 0 is the default.
Examples:
Example of setting up a handsfree unicast call between two panels:
send_command TP1, "^ICS-192.168.0.3,9000,9002,2"
send_command TP2, "^ICS-192.168.0.4,9002,9000,2"
Example of setting up a multicast call where the first panel is paging two other panels:
send_command TP1, "^ICS-239.252.1.1,9002,9000,1"
send_command TP2, "^ICS-239.252.1.1,9002,9000,0"
send_command TP3, "^ICS-239.252.1.1,9002,9000,0"
Example of setting up a baby monitor call where the first panel is listening to the micro-
phone audio coming from the second panel:
send_command TP1, "^ICS-192.168.0.3,9000,9002,0"
send_command TP2, "^ICS-192.168.0.4,9002,9000,1"
^ICE'
Intercom end.
Intercom end. This terminates an intercom call/connection.
Syntax:
SEND_COMMAND <DEV>,"'^ICE'"
Variables:
None.
Example:
SEND_COMMAND TP1,"'^ICE'"
SEND_COMMAND TP2,"'^ICE'"
Terminates an intercom call between two panels.