![background image](http://html1.mh-extra.com/html/amx/enova-dvx-3150hd/enova-dvx-3150hd_operation-reference-manual_2939055079.webp)
Audio/Video Configuration
66
Enova DVX-3150HD/3155HD All-in-One Presentation Switcher Operation/Reference Guide
System Settings
FIG. 61 displays the System page. The System page allows you to switch any audio or video input to any
output, set the front panel button lockout, adjust front panel LED and LCD intensity, and view the device
information for the switcher.
FIG. 61
WebConsole Configuration page - System page
1 -
Input/Output Matrix
: Select an option button under each output to switch video or audio from the
corresponding input to that particular output. Green text indicates a signal is detected, grey indicates a
signal is detected but cannot be identified, and red indicates no signal is detected. You can only select
one video and audio input at a time per output. Select None if you do not want any video or audio on the
selected output.
2 -
Save/Load
: Click the buttons to save or load your DVX settings. Files are saved as a .xdv file to any
local or network drive of your specification.
Note:
Due to the way many browsers manage file upload requests while in an authenticated session, it is
not possible to load a DVX setup (.xdv) file with any web browser AMX has tested, except Microsoft
Internet Explorer when HTTP Security is enabled on the DVX Master.
3 -
Microphone Mode
: Click the checkboxes to activate or deactivate the microphones connected to Mic
Inputs 1 and 2 when in Dual Mode, or the L/R Microphone when in Single Stereo Mode.
4 -
Front Panel Lockout Mode
: Click the check box to activate a lockout of some or all of the buttons on
the front panel. Select the type of lockout in the Lockout Mode section. Select Full Lockout if you want the
lockout to block the use of all front panel buttons. Select Menu-only Lockout if you want the lockout to
only block the use of the menu options on the front panel. The Switch, Take, Status, Volume, and Mute
buttons are still available with this option.
5 -
Front Panel Backlight
: Use the sliders to adjust the backlight intensity of the LCD display and the
LEDs on front panel buttons. You can set the backlight intensity for each option between 0 and 100. The
default setting for each option is 50.
6 -
System Information
: This area provides the following read-only information about your unit:
• Serial number
• MAC Address
• IP Hostname
• IP Address
• IP Subnet Mask
• IP Gateway
• IP DNS Addresses
• Switcher Firmware Version
• Master Firmware Version
• Device Firmware Version
• Temperature (ºC)
• Temperature Alarm
• Fan Speeds (RPMs)
• Fan Alarm
• Standby Mode
1
3
4
5
6
2