![background image](http://html1.mh-extra.com/html/amx/enova-dvx-3150hd/enova-dvx-3150hd_operation-reference-manual_2939055071.webp)
Audio/Video Configuration
58
Enova DVX-3150HD/3155HD All-in-One Presentation Switcher Operation/Reference Guide
Uploading an Image File
You can upload static image files to the DVX and display the logo images on a video output. You can upload
up to three images to the unit. There is 8192kb of flash memory available for storing the three image files. The
amount of free space remaining appears on the Video Out tab. Images must be 24-bit color bitmap files at least
36x36 pixels in size.
Perform these steps to upload an image file:
1.
Open a web browser.
2.
Enter the IP address of the All-In-One Presentation Switcher in the location bar of the web browser. (If
you do not know your switcher’s IP address, see the
Locating the IP Address of the DVX
section on
page 56.) The Main WebControl page opens (FIG. 55).
3.
Use the Device options menu at the top of the screen to select the
<DEVICE #> - DVX-315xHD-xx
Switch Device
. (Substitute the model number of your unit for x.) The Configuration page opens in a
separate pop-up window (FIG. 57).
4.
On the Video Out tab, click
Upload File
. (You can click any of the three available buttons.)
5.
Select an image file from a location accessible to the DVX and click
OK
.
6.
Once the file is uploaded, click
Flash Logos
to load the images files into memory.
7 -
Logo Setup
: The Logo Setup area enables you to load up to three bitmap image files available for display
on the video output. Click each Upload File button to locate and upload an image file to the unit’s local memory,
then click the Flash Logos button to load the image files into memory. Images must be 24-bit color bitmap files
at least 36x36 pixels in size. There is 8192kb of flash memory available for storing the three image files. The
amount of free space remaining appears on the screen. See the
Uploading an Image File
section on page 58
for more information.
Note:
Large images can cause a slowdown in performance. Though images up to 1920x1200 are supported,
AMX recommends using an image size no greater than 640x480.
8 -
Scaling
: Click Auto to have the unit automatically set the video resolution for the selected output display
based on the EDID information received from the connected display device. Click Manual to manually override
the video resolution for the output display. After choosing Manual, select a resolution and an aspect ratio from
the corresponding menus. Select Bypass to disable scaling and send unscaled video from the selected input to
the display.
9 -
DXLink
: This section enables you to establish scaling and aspect ratio settings for the DXLink outputs. If
these outputs are not available on your unit, this area appears greyed-out.
10 -
Image Settings
: Use the sliders to set the brightness and contrast for the selected video output.
11 -
Video Adjustments
: Use the sliders to set the horizontal and vertical size and shift and the zoom for the
selected video output.
Your video configuration is not affected by a power loss, restarting the unit, or
upgrading the firmware.
Large images can cause a slowdown in performance. Though images up to
1920x1200 are supported, AMX recommends using an image size no greater than
640x480.
Using concurrent web browsers or users while uploading or flashing image files can
cause corruption in your images. It is a best practice to use only a single web browser
when uploading or flashing an image file.
Closing and restarting your web browser removes all current image file information
from the Web Console page. However, if you completed uploading the image, the
images are still loaded into the DVX’s memory.