American Dynamics AD615, Operator'S Manual

Page: 36 / 80

Alarms, Areas and Home Settings 4-7
•
If you want to define areas, continue with Programming Area Boundaries on
page 4-9.
•
If you want to define presets, continue with Programming Presets on page 4-11.
•
If you are finished making changes, press and hold
Iris Close
, then press
Focus
Near or Focus Far to save your changes and exit the utility.
3
•
If you want to make changes to other settings, use the Tilt control to move the
highlight bar to Exit , then press
Focus Far
. The Dome Configuration Menu
appears. Continue with What To Do Next on page 4-14.
Assigning the Dome’s Home Position
When Configure Home Position is selected from the Alarms/Areas/Home screen, the
following is displayed:
CONFIGURE HOME POSITION
EXIT
HOME POSITION PRESET 96
10 RETURN TIME MINS
Figure 4-4: Configure Home Position Screen
Use this screen if you want the dome return to a preset or run a pattern after a specified
period of inactivity.
Note When a pattern is selected as the home position, the pattern runs until it
stopped manually by issuing a camera command, such as tilt or focus.
Setting the Home Position
1. Select Alarms/Areas/Home from the Dome Configuration Menu .
2. Use the
Tilt
control to move the highlight bar to Configure Home Position , then press
Focus Far .
The highlight bar appears on the Home Position setting.
3. Press
Zoom In
or
Zoom Out
to change the setting.
3
This command is not supported with Manchester.
Highlight Bar:
Move with Pan/
Tilt control.