7.
Replace the worn cutting disc with a new cutting
disc.
8.
Put on and tighten the bolts on the bearing seat.
9.
Install the new cutting disc.
10.
To ensure that the cutting discs touch slightly,
adjust the spacing of the cutting discs with the
spacer discs
5
.
11. Install spacer discs that are not required on the
opposite side of the cutting disc bearing with the
central bolt.
12. Put on and tighten the central bolt.
13. Install the dust caps.
10.1.8 Adjusting the cutting disc distance on the FerTeC Twin coulter
INTERVAL
Every 100 operating hours
or
as required
With increasing wear of the cutting discs, the distance
between the cutting discs also increases.
1.
Remove the dust caps
1
.
2.
Unscrew and remove the central bolts
2
.
NOTE
The central bolts have different threads:
The right central bolt has right-hand thread
The left central bolt has left-hand thread
3.
To ensure that the cutting discs
5
touch
slightly,
remove or add spacer discs
4
as required.
4.
Install spacer discs that are not required on the
opposite side of the cutting disc bearing with the
central bolt.
1
2
3
4
220 Nm
CMS-I-00002019
CMS-T-00002380-E.1
10 | Repairing the machine
Maintaining the machine
MG6659-EN-GB | F.1 | 25.10.2022 | © AMAZONE
155
