Amano PIX-200, Operation Manual

Page: 7 / 48

Amano PIX-200 Operation Manual
1-3
LCD Display
The LCD display contains an ink capacity gauge. This gauge indicates the
amount of ink remaining in the ribbon cartridge using four bar segments, from
E (Empty) to F (Full).
The PIX-200 calculates the remaining ink capacity of the ribbon cartridge from
the number of imprints made. As the ink capacity decreases, the bars in the
gauge will disappear. When the ribbon reaches below 25% capacity, the word
“INK” and “E” will blink until the ribbon is replaced and the ink counter is reset.
(Refer to page 5-1 for Ribbon Cartridge Replacement and Ink counter reset).
The following drawing illustrates the PIX-200 LCD display contents.
Description of Controls (function buttons)
Normally, the Display Window shows the date and time. When you use the
Quick Set or Program Mode to change the settings of the PIX-200, the
instructions to change the clock are shown in this window.
The 5 function buttons underneath the cover are used to navigate through the
Quick Set and Program Mode to change the clock’s settings.
•
The (-) button is used to change the information on the display by
decrementing the set value or moving the “ ▲ ” to the left.
•
The (+) button is used to change the information on the display by
incrementing the set value or moving the “ ▲ ” to the right.
•
The E button is used to accept the information shown on the display and
save it in memory.
•
The +1 HOUR button advances the hour in the display by increments of 1.
•
The +1MIN. button advances the minutes in the display by increments of
1.
Ribbon Cartridge
Ink Capacity
Day of the week / Program Indicator
Program Indicator
Atomic Time
Synchronization Indicator
Date (Year, Month, Date) / Number /
Repeat Times
Time (Hour:Minute:Second)
/Programming
AM/PM Indicator