Amano PIX-200, Operation Manual

Page: 39 / 48

Amano PIX-200 Operation Manual
5-1
Chapter 5: Maintenance and Troubleshooting
Ribbon Cartridge Replacement
NOTE: Before replacing the ribbon cartridge, disconnect the power plug from
the power outlet.
1.
Insert the key provided and turn
counterclockwise to unlock the cover. Lift the
cover to remove.
2.
Pull the two ribbon release tabs upward.
3.
While holding the release tabs in an upward
position, pull the ribbon cassette out of the
cradle.
4.
If the print mechanism is down and a piece
of paper cannot be inserted, unplug the
clock, then plug it back in to move the
carriage up. This will make the ribbon
installation easier.
5.
Insert a new ribbon underneath the printer
head as shown.
6.
Turn the knob on the cassette clockwise one
turn to take up any slack in the ribbon.
7.
Check the printing quality to confirm that you
have installed the ribbon properly.
8.
Reset the INK capacity gauge by pressing
the (
+ ) and (
-
) buttons at the same time for
more than 2 seconds.
9.
Replace the cover.
Cleaning
For cleaning, unplug the power cord and wipe the case with a dry cloth. Do not
use any chemical solvents or oils to clean or lubricate your PIX-200. This will
damage your clock.
To clean the inside of your clock, blow it out with compressed air.