Amano PIX-200, Operation Manual

Page: 24 / 48

3-12
Amano PIX-200 Operation Manual
13.
Press the ( E ) button once to confirm the setting, and display “ P9 End ” to
finish setting the printing pattern. Press the ( E ) button once again to return
back to the “ SEt UP Pro9 ” display.
Setting the Printing Length
The illustrations to the right show samples of the displays. The shaded area
means that the symbols, numbers or characters are blinking.
The PIX-200 will automatically change the character font to accommodate the
allowed print length when you set the print length. However, if you have
selected to use the Customized Comments, this function is not performed and
the font is not automatically changed to vary the printing length. The printing
length is input in millimeters (MM). If the value is smaller than the minimum
length, you will see an error message (
Error 05 ) when the cover is put back
on. The minimum length depends on the imprint format you have chosen,
while the maximum length is 35mm.
To change print length perform the following:
1.
Unlock and remove the cover.
2.
Press the (+ ) and ( E ) buttons on the top
of the unit at the same time, and hold
down for 2 seconds until
SEt UP Pro9
appears on the display. The “ ▲ ” on the top
of the display will be blinking.
3.
Press the ( + ) button five times to position
the “ ▲ ” under the SAT .
4.
Press the ( E ) button once to display “ Pr
LEnth ” blinking to select the printing length
5.
Press the ( - ) or ( + ) button to select the
desired print length. Press the ( E ) button to
confirm the setting and return the display to
SEt UP Pro9 . If an Error 05 message
should appear on the screen, change the
print length by repeating steps 4 and 5.
MON TUE WED THU FRI SAT SUN
Blinking
▲
８ ＳＥｔ ８ ＵＰ ８
８ Ｐ ｒｏ
９ ８
▲
Ｐｒ ８ Ｌ Ｅｎｔｈ
８８ ３５
８８
MON TUE WED THU FRI SAT SUN