DTMF Programming
3-14
Installation and Programming Manual
x
Message Light On 2. Same as Message Light On 1 but used only for PBXs
that have two different codes for different telephones or for special tone
notification (see Table 3-3).
The system administrator can set the notification method to one of the two states
(code *760):
Notification on 1
st
new message
Notification on every new message
x
Sign Rings. The MiniSOHO rings the notified extension number. These Sign
Rings may be sent at programmed intervals (code *720). The MiniSOHO stops
sending Sign Rings after the mailbox owner retrieves all his new messages or
the maximum number of retries has been made (code *750).
x
Rings. The MiniSOHO rings the notified extension for a programmed time
period (code *730). When the mailbox owner answers, the MiniSOHO prompts
him to enter his password. After entering the password, the mailbox owner may
retrieve his messages. If the mailbox owner does not answer, the MiniSOHO
tries again at programmed intervals (code *720). The MiniSOHO stops sending
Ring notifications after the mailbox owner retrieves all his new messages or the
maximum number of retries has been made (code *750).
Remote Notification
The mailbox owner may choose to be notified at a remote location (i.e., his mobile
telephone, home telephone or pager) by entering a remote telephone number (of up
to 20 digits) or pager number (of up to 40 digits). You can use any combination of
*, #, A-D, 0-9, and Pause when setting the remote notification telephone number.
After remote notification is enabled, the MiniSOHO will dial the remote phone or
pager number and notify the mailbox owner of any new messages. After entering
the password, the mailbox owner can retrieve his messages. The duration of remote
notification rings is programmed using code *730.
The MiniSOHO stops sending Ring notifications after the mailbox owner retrieves
all his new messages or the maximum number of retries has been made (code
*750). The mailbox owner must obtain permission from the System Administrator
to enable remote notification. The System Administrator must use code *710 or
*711 to grant permission.
The remote notification activation time can be programmed so the administrator
can decide on the daylights hours for the external notification to be activated. The
time span of this service is programmed using code *490.
