Amada IS-300CA, Operation Manual, Page: 65 / 208

CHAPTER 3: USING PROGRAMMING FUNCTIONS
IS-300CA INVERTER POWER SUPPLY
990-418 3-35
GOOD:
Count-up is done if the judgment is
GOOD
in current-supplied monitoring.
In case of errors other than the counter error, count-up is not done. Also, when the welding is
interrupted, count-up is not done.
Judgment in Monitor Counting Manner
GOOD (normal)
Count-up.
Upper/lower
limit monitor
CAUTION
No Count-up. ERROR
Error/Interrupt
WORK:
Count-up is not done if the judgment is
ERROR
in current-supplied monitoring.
Judgment in Monitor Counting Manner
GOOD (normal) WELD Counter counts-up.
WORK Counter counts-up (increment of+1) when
WELD Count reached the set value.
Upper/lower
limit monitor
CAUTION
ERROR WELD Counter does not count-up.
WELD Counter is reset to 0 (zero) when NG is
reset. WORK Counter does not count-up.
Error
Interrupt
WELD Counter does not count-up.
Since an error does not occur, the error reset is not
received.
q. SCAN MODE
Cannot be used. Select OFF.
r. COMM CONTROL
Selects a communication function.
OFF No communication

One-way communication

Both-way communication
s. COMM MODE
Selects a communication mode.
RS-485
(optional)
Communication by RS-485
RS-232C Communication by RS-232C