Alpine INE-W957A, Owner'S Manual

Page: 19 / 192

19
-EN
01GB05INE-W957A.fm
ALPINE INE-W957A 68-24567Z47-A (EN)
Turning the System On
With the Alpine system, when the ignition key is turned to ACC or ON,
the opening screen will be automatically displayed.
1
When the system is used for the first time, the
language selection menu is displayed. There are 24
languages to choose from. Touch
[ ] or [ ] to
scroll the list, and then touch the desired language.
• You can also scroll through lists by touching the screen and
sliding your finger up and down.
2
Touch [OK] .
The radio screen is displayed.
• Some of this unit’s functions cannot be performed while the vehicle is
in motion. Be sure to stop your vehicle in a safe location and apply
the parking brake before attempting these operations.
Initial System Start-Up
Be sure to press the RESET switch when using the unit for the first
time, after changing the car battery, etc.
1
Turn off the unit power.
2
Press RESET switch with a ballpoint pen or similar
pointed object.
Inserting/Ejecting a Disc
1
Press
c
(Eject).
The Open/Tilt screen is displayed.
2
Touch
[
c
Disc]
.
3
Insert the disc with the label side facing up.
Insert the disc until it is automatically pulled into the unit.
The unit starts to play the disc.
* The SD memory card does not support Music/Video playback.
For details on how to use SD memory cards, refer to “Navigation
system OM”.
• To remove the SD memory card, touch [ SD].
• Insert the SD memory card into the slot until it is locked.
If the SD memory card is not inserted properly, the monitor cannot be
closed.
1
Press
c
(Eject).
The Open/Tilt screen is displayed.
2
Touch [
c
Disc] .
The monitor will open. Then the disc is ejected.
When the disc has been ejected part way, take it out.
• Even if no disc is inserted, the monitor will open after touching
[
c
Disc] .
3
Touch [Close] , or press
c
(Eject).
• If the disc does not eject after touching [
c
Disc] , press and hold
c
(Eject) for at least 5 seconds.
• Do not apply shock to the monitor when it is open as it may result in
malfunction of the unit.
• The monitor will stop at the set tilt angle when closing.
RESET switch
Inserting the Disc
Removing the Disc
CAUTION
Keep hands (or any other object) away from the monitor while it
is opening or closing to avoid damage or injury. The back of the
monitor tends to become very warm under normal operating
conditions. This is not a malfunction, but care should be taken to
avoid prolonged contact with it.
SD memory
card slot
*
Disc Slot
01GB00INE-W957A.book Page 19 Monday, April 21, 2014 7:49 PM