48
-EN
01GB05INE-W957A.fm
ALPINE INE-W957A 68-24567Z47-A (EN)
Adjusting the Time Correction (Time
Correction)
[Time Correction]
is selected on the Sound setup menu in step 3. Refer
to “Sound Setup Operation” (page 45).
Before performing the following procedures, refer to “About Time
Correction” (page 49).
Setting item: Time Correction
1
Touch
[cm]
,
[inch] or [ms]
to select mode for
making adjustments.
Each time you touch, the onscreen button and correction
mode changes.
cm/inch: Adjust listening position and distance from each
speaker.
ms: Adjust time.
2
Touch
[
]
or
[
]
for each speaker to adjust the
time or distance.
0.0 msec to 9.9 msec (0.1 msec/step)
0.0 cm (0.0 inch) to 336.6 cm (132.7 inch) (3.4 cm/step)
All speaker setting values are adjustable in the range of 15 ms
or 510 cm.
3
To store the adjusted setting value, touch and hold
[Preset1]
,
[Preset2]
, or
[Preset3]
for at least 2
seconds.
•
Touch
[Flat]
to set all values to 0.0.
•
If the Rear Speaker setting is “Off”, the Rear Speaker setting cannot
be edited (refer to page 46).
•
If the Subwoofer setting is “Off”, the Subwoofer setting cannot be
edited (refer to page 46).
Calling the Time Correction Value
Calling the pre-set time correction value.
Touch
[Preset1]
,
[Preset2]
, or
[Preset3]
on the time
correction screen.
The setting stored in the Preset will be recalled.
Adjusting the Crossover Settings
(X-OVER)
[X-OVER]
is selected on the Sound setup menu in step 3. Refer to
“Sound Setup Operation” (page 45).
Before performing the following procedures, refer to “About the
Crossover” (page 50).
Setting item: X-OVER
1
Touch
[Channel]
to select the channel.
Each time you touch, the channel switches.
•
The channel being adjusted is displayed in red.
2
Adjust the crossover to your preference.
Selecting the Cut-Off Frequency
Touch
[
]
or
[
]
of “Freq.”, and then select the cut-off
frequency.
Setting contents: 20 / 25 / 31.5 / 40 / 50 / 63 / 80 (Initial setting) /
100 / 125 / 160 / 200 Hz
Adjusting the Slope
Touch
[
]
or
[
]
of “Slope”, and then adjust the HPF or LPF
slope.
Setting contents: 0 (Initial setting) / 6 / 12 / 18 / 24 dB/oct.
Adjusting the Level
Touch
[
]
or
[
]
of “Level”, and then adjust the HPF or LPF
level.
Setting contents: -12 to 0 dB (Initial setting: 0)
3
Repeat steps 1 to 2 to make adjustment to the other
channels.
Correction mode
Front HPF
Rear HPF
Subw. LPF
01GB00INE-W957A.book Page 48 Monday, April 21, 2014 7:49 PM
Summary of Contents for INE-W957A
Page 169: ...60 2 Tap to stop the simulation...
