Syntax
+PMHR
Response
+PMHR:<value>
<value> Decimal number corresponding to the maximum hold time the
server or hold-granting modem will allow.
0 V.92 MOH request denied or not available.
1 MOH with 10 second timeout Granted.
2 MOH with 20 second timeout Granted.
3 MOH with 30 second timeout Granted.
4 MOH with 40 second timeout Granted.
5 MOH with 1 minute timeout Granted.
6 MOH with 2 minute timeout Granted.
7 MOH with 3 minute timeout Granted.
8 MOH with 4 minute timeout Granted
9 MOH with 6 minute timeout Granted.
10 MOH with 8 minute timeout Granted.
11 MOH with 12 minute timeout Granted.
12 MOH with 16 minute timeout Granted.
13 MOH with indefinite timeout Granted.
Result Codes
OK 0-13 in V.92 Mode (+MS=V92)
ERROR Otherwise
+PIG - PCM Upstream Ignore
This command controls the selection of PCM upstream in the modem. The actual state of
PCM upstream is determined by the state of this command as well as the state of a negotiated
handshake with a V.92-compliant server in V.92 Mode.
Note:
This command is not applicable to HCF products.
Syntax
+PIG=<value>
Defined Values
<value> Decimal number corresponding to the selected operation.
0 Enable PCM upstream negotiation.
1 Disable PCM upstream negotiation. (Default.)
Result Codes
OK 0 or 1 in V.92 Mode (+MS=V.92)
ERROR Otherwise
Reporting Selected Value(s)
Command: +PIG?
Response: +PIG: <value>
Example: +PIG: 1 For the default setting.
Reporting Supported Range of Parameter Values
Command: +PIG=?
Response: +PIG: (<value> range)
Example: +PCW: (0,1)
+PMHF - V.92 Modem-on-Hold Hook Flash
This command causes the modem to initiate the flash hook sequence when in the modem-onhold
procedure. This enables switching to the second call (incoming or outgoing). This
command applies only to V.92 modem-on-hold. There are no parameters associated with this command.
Syntax
+PMHF
Result Code
