non-zero, the test will terminate automatically after the time specified by S18 and the OK
result code will be reported.
Syntax
&T[<value>]
Defined Values
<value> Decimal number corresponding to the selected value.
0 Terminates test in progress.
1 Initiates local analog loopback, V.54 Loop 3. If a
connection exists when this command is issued, the
modem hangs up. The CONNECT XXXX message is
displayed upon the start of the test.
I - Request Identification Information
This command causes the modem to report one or more lines of product information text, as
selected by the <value> sub parameter, followed by a final result code.
Syntax
I [<value>]
Defined Values
<value> Decimal number corresponding to the selected information.
0 Reports product code, e.g.:
ATI0
56000
OK
1 Reports the least significant byte of the stored
checksum in decimal (see firmware release notes).
Reports 255 if the prestored checksum value is FFh, e.g.,
ATI1
255
OK
2 Reports OK, e.g.:
ATI2
OK
OK
3 Reports identification codes, e.g.:
ATI3
2.1.2.127
OK
4 Reports product description from the .INF file (the response is customizable by customizing the INF
file), e.g.:
ATI4
HCF 56K Data,Fax,Speakerphone
OK
5 Reports Country Code parameter (in decimal), e.g.:
ATI5
181
OK
6 Reports modem data pump model and internal code revision, e.g.:
ATI6
DP Rev
V90 SPX RAM Ver 28
V90 CTL RAM Ver 28
K56FLEX SPX RAM Ver 44
K56FLEX CTL RAM Ver 47
OK
7 Reports modem data pump model and internal code revision, e.g.:
