-QCPC - Force Full Startup Procedure Next Connection
This command causes the modem to use full startup procedures on the next connection
attempt regardless of the setting of the +PQC command. After this attempt, the modem will
select the startup procedure as defined by the +PQC command. If a shortened startup
procedure is enabled by the +PQC command, then the quick connect profile will also be
updated on the next connection attempt.
Syntax
-QCPC
Result Code
OK In V.92 Mode (+MS=V.92)
ERROR Otherwise
-QCPS - Enable Quick Connect Profile Save
This command controls whether or not the modem will save the generated quick connect profile.
Syntax
-QCPS=<value>
Defined Values
<value> Decimal number corresponding to the desired operation.
0 Do not allow the quick connect profile to be saved.
1 Allow the quick connect profile to be saved. (Default.)
Result Codes
OK 0 or 1 in V.92 Mode (+MS=V.92) and quick connect is enabled
(+PSS = 0)
ERROR Otherwise
Reporting Selected Value(s)
Command: -QCPS?
Response: -QCPS: <value>
Example: -QCPS: 1 For the default setting.
Reporting Supported Range of Parameter Values
Command: -QCPS=?
Response: -QCPS: (<value> range)
Example: -QCPS: (0,1)
3.3 S-Parameters
The supported S-Parameters are summarized in Table 3-14.
Table 3-14. S-Parameter Summary
Register Function Units
S0 Number of Rings to Automatic Answer rings
S1 Ring Counter rings
S2 Escape Character ASCII
S3 Line Termination Character ASCII
S4 Response Formatting Character ASCII
S5 Command Line Editing Character ASCII
S6 Wait Time for Dial Tone Before Blind Dialing, or After “W” Dial Modifier s
S7 Wait Time For Carrier After Dial, For Silence, or For Dial Tone After “W” Dial Modifier s
S8 Pause Time for Dial Delay Modifier s
S10 Carrier Loss Disconnect Time 0.1 s
S11 DTMF Tone Duration 0.001 s
S12 Escape Prompt Delay 0.02 s
S18 Test Timer s
S29 Flash Dial Modifier Time 10 ms
S30 Disconnect Inactivity Timer 10 s
S46 Data Compression Control -
S95 Result Code Messages Control –
AT=x - Write to Selected S-Parameter
