The parameters defined in this section control the operation of the interface between the DTE and
modem.The modem enables or disables the echo of characters to the DTE according to the parameter
supplied.
Syntax
E[value>]
Defined Values
<value> Decimal number corresponding to the selected option.
0 Disables command echo.
1 Enables command echo. (Default.)
Result Codes
OK <value> = 0 or 1.
ERROR Otherwise.
Q - Quiet Results Codes Control
The command enables or disables the sending of result codes to the DTE according to the
parameter supplied. The parameter value, if valid, is written to S14 bit 2.
Syntax
O[value>]
Defined Values
<value> Decimal number corresponding to the selected option.
0 Enables result codes to the DTE. (Default.)
1 Disables result codes to the DTE.
Result Codes
OK <value> = 0 or 1.
ERROR Otherwise.
V - Result Code Form
This command selects the sending of short-form or long-form result codes to the DTE.
Syntax
V[value>]
Defined Values
<value> Decimal number corresponding to the selected option.
0 Enables short-form (terse) result codes. Line feed is
not issued before a short-form result code.
1 Enables long-form (verbose) result codes. (Default.)
Result Codes
OK <value> = 0 or 1.
ERROR Otherwise.
W - Connect Message Control
This command, in conjunction with S95 bits 0, 2, 3, and 5 (bits 2, 3, and 5 can be written
directly by the host or by the +MR, +ER, and +DR commands, respectively), control the
format of CONNECT messages (see Section 3.5 and Table 3-15). The actual result code
messages reported reflect the W command setting and the S95 bit settings. (Also see +MR,
+ER, and +DR commands.)
Syntax
W[value>]
Defined Values
<value> Decimal number corresponding to the selected option.
0 Upon connection, the modem reports only the DTE
speed (e.g., CONNECT 19200). Subsequent
responses are disabled. (Default.)
